ip netstream sampler fix-packets 1200 outbound quit quit save ip netstream outbound ip netstream sampler fix-packets 1200 inbound //Configure the sampling mode to regular packet sampling. You are advised to enable NetStream in inbound direction of uplink and downlink interfaces or in both directions of the uplink or downlink interface. interface gigabitethernet 1/0/1 ip netstream inbound //Configure the sampling direction. You only need to enter one port number.) ip netstream timeout active 60 //Configure the active flow aging time. (The default port number is 9995 or 9996. Use the IP address and port number of the NSC. ip netstream export host 10.137.58.83 9995 //Configure the destination address and port for exporting packets. The IP address must exist on the device and the device must use this IP address when it connects to eSight. system-view ip netstream export source 10.137.59.152 //Configure the source address for exporting NetStream packets. Huawei S9700 NetStream V5 is taken as an example.For other device models, see the corresponding configuration manual. This section uses typical Huawei devices as an example. NetStream parameters are set on devices to enable the devices to report traffic statistics to the NTC.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |